PosSim FS can be used to generate synchronous SINE and COSINE signals as they are provided by position sensors applied in electrical motors. There are several expansion stages of the simulation. One group provides 5 analog outputs. Different numbers of outputs can be realized by combining several groups. The PosSim FS system can be controlled via Ethernet or CAN-FD.
The hardware platform is based on National Instruments sbRIO-9608.
Document overview
This document contains 3 sections.
- The first section includes an introduction to this manual.
- The second section includes description of the hardware.
- The third section includes accessing the system from the software point of view.
Purpose of this document
Purpose of this document is to describe how to integrate the PosSim FS system in a test system and how to access it from the software point of view. Limits of application are shown in the technical data section. This document is addressed to system integrators and the users, who are applying the PosSim FS system.
Definitions and abbreviations
| Abbreviation | Definition |
|---|---|
| RPS | Rotor Position Sensor |
| AO | Analog Output |
| NI | National Instruments |
| CAN FD | Controller Area Network Flexible Data-Rate |
| DUT | Device Under Test |
| PosSim FS | Position sensor simulation with fault simulation |
| API | Application Programming Interface |
| sbRIO | Single Board RIO |
| DBC | data base CAN |
Table 1: Definitions and abbreviations
Documents and downloads
Further documents and files for your IRS product are available on myIRS.